Hello ,
I have an issue with sera reactor 1000. It is only 2 days now that i am using it and i cant see any co2 in my measurements , drop checker is blue and my ph high.
It is very weird since my connections are fine , there are no leaks and i am putting about 4-5 bubbles/s into 60 gallon of water.
I can see the small bubbles into the chamber but i can also see some bubbles escaping from the output (any solution for this?)
My filter is jbl 1501e.
So, my main issue is that for some reason there is no co2 into my tank. If i change to my inline difusser at the same rate of b/s , my dropchecker turns green. With the reactor it is like i dont put any co2 inside.
And a minor issue is that i see water into the co2 hose when the co2 is off. It is between the check valve and the reactor . Probably gravity? Is this a problem?
Thank you for your time
I have an issue with sera reactor 1000. It is only 2 days now that i am using it and i cant see any co2 in my measurements , drop checker is blue and my ph high.
It is very weird since my connections are fine , there are no leaks and i am putting about 4-5 bubbles/s into 60 gallon of water.
I can see the small bubbles into the chamber but i can also see some bubbles escaping from the output (any solution for this?)
My filter is jbl 1501e.
So, my main issue is that for some reason there is no co2 into my tank. If i change to my inline difusser at the same rate of b/s , my dropchecker turns green. With the reactor it is like i dont put any co2 inside.
And a minor issue is that i see water into the co2 hose when the co2 is off. It is between the check valve and the reactor . Probably gravity? Is this a problem?
Thank you for your time