KirstyF
Member
Hi There. I have a co2 art pro elite series with additional manifold. I am running alot of bubbles, too many to count through both manifolds.
Working pressure is set at 45psi, remains stable throughout usage period and is still showing 45psi just prior to the solenoid starting up the next day. As soon as the solenoid kicks in, however, the pressure drops to about 15psi and I have no Co2 coming through. If, at this point, I turn the working pressure on as far as it will go, it will still not bring this up to a functional pressure.
To resolve this I have had to shut everything off, including the cylinder, release the pressure from the tank by loosening the nut, re-tighten and turn the gas back on (with working pressure valve on fully closed) switch the solenoid on and then use the working pressure valve to bring the pressure back up to 45psi.
It will then run fine and completely stable until the next day when the whole issue starts over.
How do I solve this so that it will function without intervention?
Working pressure is set at 45psi, remains stable throughout usage period and is still showing 45psi just prior to the solenoid starting up the next day. As soon as the solenoid kicks in, however, the pressure drops to about 15psi and I have no Co2 coming through. If, at this point, I turn the working pressure on as far as it will go, it will still not bring this up to a functional pressure.
To resolve this I have had to shut everything off, including the cylinder, release the pressure from the tank by loosening the nut, re-tighten and turn the gas back on (with working pressure valve on fully closed) switch the solenoid on and then use the working pressure valve to bring the pressure back up to 45psi.
It will then run fine and completely stable until the next day when the whole issue starts over.
How do I solve this so that it will function without intervention?