Hi all,
I was fortunate to recently acquire co2 art's advanced sodastream adapter kit, with a couple of sodastream bottles from a member on here.
After setting up, and opening the bottle by turning clockwise; I'm getting a large escape of gas from between the adapter and the sodastream bottle. After querying, it sounds like I have misplaced a rubber seal? Can anyone be kind enough to show a pic of this, or if there is anywhere special the seal is supposed to sit? I'm assuming it just goes into the adapter next to the pin?
I've also tightened the regulator part with a spanner very tightly, haven't experienced any loss there
I was fortunate to recently acquire co2 art's advanced sodastream adapter kit, with a couple of sodastream bottles from a member on here.
After setting up, and opening the bottle by turning clockwise; I'm getting a large escape of gas from between the adapter and the sodastream bottle. After querying, it sounds like I have misplaced a rubber seal? Can anyone be kind enough to show a pic of this, or if there is anywhere special the seal is supposed to sit? I'm assuming it just goes into the adapter next to the pin?
I've also tightened the regulator part with a spanner very tightly, haven't experienced any loss there
Last edited: