Wookii
Member
I'm looking to mod a filter housing in order pass a cable through either the lid or wall - for example to add a heater or sensor inside the housing - but I need to it be non-permanent such that it can be undone and the cable removed if required.
I therefore need some sort of rubber grommet or cable gland that can be fitted to a hole in the canister lid or body, but will seal water tight around the cable to prevent leakage.
I'm looking at these but I'm not 100% confident they're really appropriate:
https://www.amazon.co.uk/dp/B06WVKDZ64/ref=psdc_1938268031_t3_B007Q846A4
Has anyone successfully used anything during their own modifications?
I therefore need some sort of rubber grommet or cable gland that can be fitted to a hole in the canister lid or body, but will seal water tight around the cable to prevent leakage.
I'm looking at these but I'm not 100% confident they're really appropriate:
https://www.amazon.co.uk/dp/B06WVKDZ64/ref=psdc_1938268031_t3_B007Q846A4
Has anyone successfully used anything during their own modifications?