Do you know which cultivar it is?
The lable says "Schizostylis coccinea Major"
This excact lable
Do you know which cultivar it is?
It was Schizostylis coccinea until fairly recently (a lot of African Irids were re-classified, Acidanthera bicolor is know Gladiolus murielae, and various Anomatheca spp. are now Freesia spp.)The lable says "Schizostylis coccinea Major"
Remind me in the spring and I'll send you a red one (they are very easy to propagate).
I thought it changed to Hesperantha, or is this also an old name changed again? The common name in our language always was Bog Gladiolus.It was Schizostylis coccinea until fairly recently
Changed from Schizostylis to Hesperantha.I thought it changed to Hesperantha, or is this also an old name changed again?
You could do a removable wooden one, same wood with cuts on the under/glas-side, you can fix the light on it and still remove it to facilitate maintenance, or to fit large woodpiecesglue in a 10cm or 15 cm wide glas strip halfway between the 2 long panels as a bridge,
You could do a removable wooden one, same wood with cuts on the under/glas-side, you can fix the light on it and still remove it to facilitate maintenance, or to fit large woodpieces
Yes it is, glaas is is still darn flexible.. As said it just looks eerie seeing a 10mm bulging out if you look over the tank.. Noticed the flexibility during the cleaning after the kitting. And thought, if it is setup and filled, the cleaning lady of the house needs to be realy gentle on the rubbing part. I kinda feel safer with glueing the bridge in.20 cm waterlevel and 4 mm should be realy safe though.
Thank you..Good looking build
Yes this also is something still ghosting through my brains. I would like to make one from brass and use rivets a la Captain Nemo style.. I while ago i played with the fantasie to build a tank like this into the wall from kitchen to living room. Than from the kitchen side a glass panel, but at the living room side 2 old brass vintage Portholes from an old boat.I'd love a vintage wrought iron framed tank.
I don't know how technical you are: http://www.confederationconstruction.be/Portals/27/Userfiles/File/glasenwaterdruk.pdf
I love some of these
The glascutter failed and made a panel almost 1mm to long. It shows in one corner, this one..
There is already kit in that corner, did cut diagonaly off.. But it's transparent and still shows.. Not a big deal. you realy have to push your nose in to see it. And it gets 2 small HOB filters, left and right.. So i'll hang the HOB in that corner.How about some minimal corner beads @zozo ?