MMonis
Member
Hi,
I am setting up a DIY Spray Bar, but I am unable to figure out the measurements involved to build one as well which part overlaps or fits into the other.
Tank dimensions : 60 cm x 30 cm x 30 cm.
External canister filter: Fluval 106
The contents that I have for now are:
PVC pipe for spray bar : I have two pvc pipes lying around
Need to buy:
2. PVC end sleeve : This at the far end of the spray bar as a shutter.
What ID/OD dimensions I need for the above "need to buy" and what fits into/over ?
Also I am noticing that my pvc tubing is kinking a bit at the point where it bends over the aquarium rim. Any suggestions/hacks for it ?
Regards,
Mel
I am setting up a DIY Spray Bar, but I am unable to figure out the measurements involved to build one as well which part overlaps or fits into the other.
Tank dimensions : 60 cm x 30 cm x 30 cm.
External canister filter: Fluval 106
The contents that I have for now are:
PVC pipe for spray bar : I have two pvc pipes lying around
- 13.6mm ID/ 16mm OD
- 16mm ID/ 20mm OD
Need to buy:
- PVC elbow 90 : I think I will need this as a connector between the PVC hose and PVC spray bar pipe.
2. PVC end sleeve : This at the far end of the spray bar as a shutter.
What ID/OD dimensions I need for the above "need to buy" and what fits into/over ?
Also I am noticing that my pvc tubing is kinking a bit at the point where it bends over the aquarium rim. Any suggestions/hacks for it ?
Regards,
Mel