andy198712
Member
Hi.
so I have a spray bar ready to go on. It’s just the standard green tube with holes drilled in it from eheim
I run a fluval 307 with the stock outlet attached with the stock grey rubber coupler.
This setup is a vertical one.
what are doing to couple and get the 90* bend required to setup the spray bar across the back?
Or are you literally just bending the flexi pipe sharply as it enters the tank ?
seems a simple question but just thought I’d ask if there was any clever neat ways around this.
cheers
Andy
so I have a spray bar ready to go on. It’s just the standard green tube with holes drilled in it from eheim
I run a fluval 307 with the stock outlet attached with the stock grey rubber coupler.
This setup is a vertical one.
what are doing to couple and get the 90* bend required to setup the spray bar across the back?
Or are you literally just bending the flexi pipe sharply as it enters the tank ?
seems a simple question but just thought I’d ask if there was any clever neat ways around this.
cheers
Andy