AquariusPeter
Member
Hi all,
Could anyone help me to check please if i do my calculations properly in this calculator for the Solufeed Sodium Free TEC?
So i set 90ltrs tank volume then 10ltr Tap water change volume and 10ltr RO water change volume.
In 'dosing regime' i set Micro Container Volume to 500ml and in Micro daily dose 10ml, Micro dosing Frequency/week 1 per week(just in case i can always increase the dosage).
On this part below in section 2 i put all my area water report taken from anglian water.
Then in Target Calculator sheet in 'Your weekly target' table i set Fe- 0.1
Now in section below in Target Calculator Sheet i put ratio 1 where is Solufeed Sodium Free TEC. As i set the target of Fe 0.1ppm that means i have to add 5.36 gram of this to the container ? Plus potassium sorbate like a preservative.
As i mentioned above, i set Fe to 0.1 ppm after dosage 10ml so during the week i may still add some more Fe if i need to.
I want to do 2 separately fertilisers, one from that Solufeed Sodium Free TEC, and the one from solufeed High K 2:1:4 in the same way.
Would you be able guys to have a look if my calculations are right to make the first solution ?
Thank you
Kind Regards,
Peter
ps. hopefully now those attachements will be working properly.
Could anyone help me to check please if i do my calculations properly in this calculator for the Solufeed Sodium Free TEC?
So i set 90ltrs tank volume then 10ltr Tap water change volume and 10ltr RO water change volume.
In 'dosing regime' i set Micro Container Volume to 500ml and in Micro daily dose 10ml, Micro dosing Frequency/week 1 per week(just in case i can always increase the dosage).
On this part below in section 2 i put all my area water report taken from anglian water.
Then in Target Calculator sheet in 'Your weekly target' table i set Fe- 0.1
Now in section below in Target Calculator Sheet i put ratio 1 where is Solufeed Sodium Free TEC. As i set the target of Fe 0.1ppm that means i have to add 5.36 gram of this to the container ? Plus potassium sorbate like a preservative.
As i mentioned above, i set Fe to 0.1 ppm after dosage 10ml so during the week i may still add some more Fe if i need to.
I want to do 2 separately fertilisers, one from that Solufeed Sodium Free TEC, and the one from solufeed High K 2:1:4 in the same way.
Would you be able guys to have a look if my calculations are right to make the first solution ?
Thank you
Kind Regards,
Peter
ps. hopefully now those attachements will be working properly.
Last edited: