TOO
Member
Hi all,
I am planning my new 75p, possibly as a paludarium. The tank is 45 cm high and my goal is to have the water surface go to about 15-18 cm. Out flow will be through a glass spray bar with the water output angled towards the glass. Problem is to find a glass inflow that is long enough to be submersed when the water level is only 15 cm or so. The issue of course not simply the height, but also how high up the pipe the inflow slits are placed. The ideal pipe would be the ball type.
I usually frown on people who send out lazy requests like these, but I have searched high and low and even been in touch with both Aquasabi and Garnelenhaus, but without a good solution. One option is to use a cut glass type pipe, but I dislike the big bend it requires for the hose to go over the side.
Long story short: have any of you come across (quality) inflows that meet the above requirements? I am also open to stainless steel type of outflow/inflow.
Best,
Thomas
I am planning my new 75p, possibly as a paludarium. The tank is 45 cm high and my goal is to have the water surface go to about 15-18 cm. Out flow will be through a glass spray bar with the water output angled towards the glass. Problem is to find a glass inflow that is long enough to be submersed when the water level is only 15 cm or so. The issue of course not simply the height, but also how high up the pipe the inflow slits are placed. The ideal pipe would be the ball type.
I usually frown on people who send out lazy requests like these, but I have searched high and low and even been in touch with both Aquasabi and Garnelenhaus, but without a good solution. One option is to use a cut glass type pipe, but I dislike the big bend it requires for the hose to go over the side.
Long story short: have any of you come across (quality) inflows that meet the above requirements? I am also open to stainless steel type of outflow/inflow.
Best,
Thomas