Cheers,
Is there a formula to work this element into the mix?
The flow only needs to go up about 30mm with no bends.
I was going to get the largest pump possible, and then t off a valve to adjust the flow. Just looking for some reassurance.
Also another quick one.
I have a tank drilled from the bottom with small bulkheads that I was going to run overflow pipes out of. I am concerned that they are too small, and will also be noisy. I also happen to have a couple of very large bulkheads from America (2 3/8 hole / 1 1/2 pipe size).
Would it be overkill to drill and run a those as overflow pipes? (38mm conversion diameter) the way I figure, is that if it is an open sump system, as long as the flow out of the the tank is more than what goes in, I should be ok.
I am drawing up some plans, that I can post on the site, hopefully someone out there could help.
R
Sent